saveOne™ ballast is uniquely developed for up to 40W fluorescent circular lamps ranging from T4 to T12. It can also be used for Halogen or Tri-phosphor coated fluorescent lamps. It is patented with a light weight feature designed to be able to be held onto circular fluorescent lamp fittings without any mechanical fastener. This cuts down installation and replacement time. It has also complied with the safety requirements of Singapore Standard SS490: Part 2:3:2002 (and IEC 61347-2-3:2000), used together with SS490 Part1:2001 (and IEC 61347-1:2000)
Unit Price : S$ 9.80
Benefits:
- Non-Flickering
-Better brightness luminance
- No starter needed
- Lower heat generated -Soft instant start - Use only 0.125A
- Easy to install
- Prolong lamp life
- Safety Mark 10142-11
Safety: Switch off the power before doing any installation of saveOne™ ballasts. Use qualified electrician for the installation.
-Install the lamp fitting with the circular fluorescent lamp onto the ceiling.
-Connect the 2 wires of the saveOne™ ballast to a 2 way connector and then connect the Live and Neutral wires of the power supply coming from the ceiling with this connector.
-Connect the earth wire onto the lamp fitting plate. Then, connect the ballast direct onto the 4-pins connection of the lamp.
-The ballast is now ready to power up the lamp.
Replacing an existing magnetic ballast with saveOne™ ballast :-
-Remove the starter holder and the starter from the existing lamp fitting.
-Connect the 2 wires of the saveOne™ ballast to a 2 way connector and then take the Live and Neutral wires of the power supply coming from the ceiling to be connected with this conector.
-You may leave the earth wire and the existing ballast as it is, as it is normally fastened beneath the ballast
-Connect the saveOne™ ballast onto the circular lamp, and its ready to power up the lamp.
ReplyDeleteI liked your blog very much it is very interesting and I learned many things from this blog which is helping me a lot.
UV Bulb Supplier